Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMMEDIATELY, remove drill bit from work, and
determine cause of stalling. DO NOT CLICK TRIGGER ON
AND OFF IN AN ATTEMPT TO START A STALLED DRILL
— THIS CAN DAMAGE THE DRILL.
5. To minimize stalling or breaking through the material,
reduce pressure on drill and ease the bit through the
last fractional part of the hole.
6. Keep the motor running when pulling the bit back out
of a drilled hole. This will help prevent jamming.
7. With variable speed drills there is no need to center
punch the point to be drilled. Use a slow speed to start
the hole and accelerate by squeezing the trigger harder
when the hole is deep enough to drill without the bit
skipping out.
Operation as a Screwdriver (Fig. A)
Select the desired speed/torque range using the dual range
gear shifter
5
on the top of tool to match the speed and
torque to the planned operation.
Insert the desired fastener accessory into the chuck
you would any drill bit. Make a few practice runs in scrap or
unseen areas to determine the proper position of the clutch
collar
.
4
MAXIMUM RECOMMENDED CAPACITIES
Low Range ( 1 )
BITS, METAL DRILLING
1/4" (6.35 mm)
WOOD, FLAT BORING
3/4" (19.05 mm)
HOLE SAWS
3/4" (19.05 mm)
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Accessories
WARNING: Since accessories, other than those
offered by D
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Repairs
The charger and battery pack are not serviceable.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D
or a D
identical replacement parts.
6
as
Protecting the Environment
Products and batteries contain materials that can be
High Range ( 2 )
recovered or recycled reducing the demand for raw
1/8" (3.18 mm)
materials. Please recycle electrical products and batteries
according to local provisions.
1/2" (12.7 mm)
5/8" (15.88 mm)
DCD700
DCD710
WALT, have not been tested with this
e
WALT factory service center
e
WALT authorized service center. Always use
e
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
spECIFICaTIoNs
12V Max*
0–400 / 0–1500 RPM
12V Max*
0–400 / 0–1500 RPM
ENGlIsh
WALT
e
33
Publicidad
Tabla de contenido
