Publicidad
Idiomas disponibles
Idiomas disponibles
2.6 While any laser line is on, you can slide the lock switch to OFF (LOCK) position. The pendulum will now be
locked.
3. Manual mode
3.1 When the lock switch is in OFF (LOCK) position, press
laser unit to project rigid non-level laser beams in any direction. The
3.2 Press the
button, the laser will be on pulse mode and then you can use the laser with a laser line detector.
Press pulse button again to exit the plus mode.
for ≥2 seconds to turn off.
3.3 Press and hold
Note:
When the laser unit is in manual mode, self-levelling mode is disabled, and all available laser lines will blink every
5 seconds.
In this mode, the available laser lines can never be trusted for level or plumb reference.
4. Note
4.1 The laser unit should be placed on a flat surface, such as desktop, ground, tripod, etc. Self-levelling range is
3°±1°. The laser lines will blink if the laser is out of self-levelling range.
4.2 Make sure to lock the pendulum when the unit is not in use and is stored for safe keeping.
5. Battery charging and installation
When the last indicator bar of the Li-ion battery is blinking, it means that the Li-ion battery capacity is low and
that it needs to be charged. Use a Type-C cable to plug into the charging port. When charging, each battery
capacity indicator bar will blink to indicate the current battery capacity. After full charging, all battery capacity
indicator bars will be solid green.
Reactivate the Li-ion battery pack if the laser unit has not been used for several months.
, the manual mode is enabled, which allows the
LED indicator turns red.
GB
7
Publicidad
