Publicidad
To protect your child! The extra pad provides your child with the support they need while he or she is even smaller.The
extra padding is used to provide extra comfort for very small babies.
Attention! Please use the extra pad attached to this car seat model until your child reaches a height of 75 cm (approx. 3
months). The newborn inlay may be removed after the baby is 75 cm to provide more space for the child. To remove the
newborn inlay open and remove the shoulder pads. Then remove the newborn inlay and place the shoulder pads back on
the shoulder belts.
Press the roation button to rotate the child seat to 180° или 360°. The seat is rotatable in both directions. By fixing in
required position (car seat FORWARD facing or REARWARD facing) you will hear a click sound. For reference see figure H:
•
Figure A: shows the Forward installation method.
•
Figure B: after rotating the seat to 180° it will be into Backward installation method.
•
Figure C: after rotating the seat respectively to 90° and 270° it will be in the baby holding position.Attention! The
function is only active when the vehicle is not in movement.
Pull the lever for recline and set the seat un required position as follows (see Figure I for reference):
•
Rearfacing seat: Five possible recline positions for the seat as shown in Figure I.3.
•
Forward-facing seat: Five possible recline positions as shown in Figure I.2.
Installation with ISOFIX and top tether (rearward facing).
Use the chair's 5-point safety harness to ensure your child's safety.
1. Install ISOFIX attachment.
2.Place the car seat tightly on the car seat in rearward facing position, fix the top tether.
3.Place the child in car seat, put and lock the 5-point safety harness.
Installation with ISOFIX and top tether (forward facing).
Use the chair's 5-point safety harness to ensure your child's safety.
1. Install ISOFIX attachment.
2.Place the car seat tightly on the car seat in forward facing position, fix the top tether.
3.Place the child in car seat, put and lock the 5-point safety harness.
Installation with ISOFIX and 3-point safety belt (forward facing) – figure L.1
1.Install ISOFIX attachments to ISOFIX slots at vehicle.
2.Place the child in the car seat and set the height of head support based on the child's height.
3.Pull the 3-point safety belt of vehicle.
4.Thread the diagonal belt though the guide of head support, and the lap through the guide of base and lock them
into the vehicle buckle.
Installation only with 3-point safety belt (forward facing) – figure L.2
1.Place the child in the car seat and set the height of head support based on the child's height.
2.Pull the 3-point safety belt of vehicle.
3.Thread the diagonal belt though the guide of head support, and the lap through the guide of base and lock them
into the vehicle buckle.
360° SEAT ROTATION- FIGURE H
BACKREST RECLINING- FIGURE I
CHILD SEAT INSTALLATION IN REARWARD FACING POSITION - FIGURE J
Using: ISOFIX + Top tether + 5-point safety harness
CHILD SEAT INSTALLATION IN FORWARD FACING POSITION - FIGURE K
Using: ISOFIX + Top tether + 5-point safety harness
CHILD SEAT INSTALLATION IN FORWARD FACING POSITION - FIGURE L
Using: ISOFIX + 3-point safety belt of the car
Using: ISOFIX + 3-point safety belt
- FIGURE B.1
- FIGURE B.1
CHILD'S HEIGHT: 40-105 cm
CHILD'S HEIGHT: 76-105 cm
CHILD'S HEIGHT: 100-150 cm
27
Publicidad
