Patron TA 55 Manual Del Usuario página 12

2. Remove the oil drain plug.
3. Tilt the product and let the oil run out into the
container.
4. Install the oil drain plug and tighten it.
5. Fill with new engine oil. Refer to
page 16 for the correct type of oil.
6. Do a check of the engine oil level.
To replace the oil in the rammer leg
1. Put a container below the oil drain plug.
2. Remove the oil drain plug.
3. Let the oil run out into the container.
4. Install the oil drain plug and tighten it. Make sure that
the sealing washer is not damaged.
12
Technical data on
5. Remove the sight glass.
6. Fill with new oil through the hole for the sight glass.
Technical data on page 16 for the correct
Refer to
type of oil.
7. Install the sight glass and tighten it fully.
8. Do a check of the oil level.
To do a check of the oil level in the
rammer leg
1. Put the product in upright position.
2. Look at the sight glass (A). The oil level is correct
when it is at the middle of the sight glass.
A
To tighten the bolts on the rammer
shoe
• Tighten the 13 bolts on the rammer shoe with a
wrench.
13x
2424 - 002 - 18.04.2024