Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
to install or remove the transport device.
Push it in and pull it away from the
product with your foot.
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
•
Attach the lifting equipment at the lifting point of the
safety frame. A label on the product identifies the
correct position.
WARNING:
product. Make sure that the safety frame
and the vibration damping units are correctly
installed and not damaged.
WARNING:
or near a lifted product.
To safety the product to a transportation
vehicle with tie-down straps
1. Set the throttle control in the stop position.
2424 - 002 - 18.04.2024
Do not use your hands
Make sure that the lifting
Do not lift a damaged
Do not walk or stay below
2. Tilt the product forward until the wheels on the
handle are on the ground.
3. Attach a strap to the lifting eye and to the vehicle.
4. Attach a strap to the lift handle and to the vehicle.
Storage
•
Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
•
Clean the product before storage. Remove clay and
sand from the rammer shoe. Remove oil and dust
from the rubber parts.
•
Apply a thin layer of oil on the rammer shoe to
prevent corrosion.
•
Clean the air filter before storage.
•
Carefully pull the starter rope handle until there is a
small resistance.
•
Put a protective cover on the product.
•
Keep the product in a dry and frost free area.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
15
Publicidad
