cecotec ENERGYSILENCE 3500 COOL COMPACT Manual De Instrucciones página 29

3. OPERATION
Switch-on
To switch on the cooler, press any of the speed mode buttons. The cooler will operate at the
selected speed.
Speed
To adjust the speed, press any of the speed buttons. Each press will adjust the speed as follows:
- : low speed/ECO
- : medium speed
- : high speed
Oscillation
Press the button to activate the oscillation function. The cooler will start to oscillate.
Press the button again to stop oscillation.
Cool function
- When the cooler is in operation, press the
- Press the button again to turn off the function.
Note: when the water tank level is low, the Cool function will not work. You will need to add
more water to the tank.
Adding water to the water tank
- Remove the water tank, located at the back of the cooler, and fill it with clean water.
- When refilling the water tank, please observe the water level marks.
- Make sure that the water level is below the "Max" mark.
- For the cooler to cool, the water level must be above the "Min" mark.
- If you want to make it even cooler, you can put cold packs or ice cubes in the water tank.
WARNING:
- The water level in the tank must be below the "Max" mark, even if cold packs or ice cubes
have been added.
- Do not add water while the appliance is running.
Using cold packs
In addition to cooling, cold packs absorb heat from the water. Therefore, if you use them, the air
coming out of the cooler will be colder.
1. Put the cold packs in the freezer. When frozen, take them out.
2. Remove the water tank and put the cold packs.
3. Two cold packs are included with the cooler.
button to activate the cool function.
ENERGYSILENCE 3500 COOL COMPACT
ENGLISH
29