Publicidad
Idiomas disponibles
Idiomas disponibles
N.B.: In the case of liquid gas, the regulation screw
must be screwed in all the way.
•
Check that the flame does not go out when you turn the
tap quickly from high to low.
d) Regulating the primary air of the burners: The primary air
of the burners does not need to be regulated.
Converting the Oven for Use with Different Types of
Gas
a) Replacing the oven burner nozzle:
•
Remove the warming drawer;
•
If the appliance comes without warming drawer, remove
the "P" panel as indicated in Fig. E. Open the door, re-
lease the two top inserts by pressing them downwards,
and then the two bottom inserts by pressing them up-
wards;
•
Remove the sliding protection (A);
•
Remove the two screws to dismount the protection (B);
(see Fig. F);
•
Remove the oven burner after having removed the "V"
screw (see Fig. G); Remove the oven door to facilitate
this operation.
•
Unscrew the oven burner nozzle using the special socket
spanner for the nozzles (see Fig. H), or a 7 mm socket
spanner, and replace it with a nozzle suited to the new
type of gas (see Table 1).
Fig. E
V
Fig. G
All manuals and user guides at all-guides.com
b) Regulating the minimum for the gas oven burner with
thermostat:
•
Light the burner as described in the paragraph "The Oven
Knob" in the instruction booklet;
•
urn the knob first to the Max setting for about 10 minutes
and then to Min;
•
Remove the knob;
•
Adjust the screw located outside the thermostat pin
until the flame is small but steady (see figure below);
N.B.: In the case of liquid gas, the adjustment screw
must be screwed all the way in.
•
Check that the burner does not turn off when you turn
the knob from Max to Min and when you open and close
the oven door quickly.
Regulating the Primary Air for the Oven Burner
The oven burner do not need to be regulated in terms of
primary air.
Important
On completion of this operation, replace the old rating sticker
with one indicating the new type of gas used. This sticker is
available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary)
A
B
from the recommended pressure, it is necessary to fit a
Fig. F
suitable pressure regulator onto the inlet pipe in
compliance with current National Regulations relative to
"regulators for channelled gas".
Fig. H
17
Publicidad
