cecotec ENERGYSILENCE 3500 COOL COMPACT SMART Manual De Instrucciones página 36

ENGLISH
3. Use a vacuum cleaner to remove accumulated dust.
4. If the grille is very dirty, soak it in hot water (the water temperature should not exceed
40°C) and rinse it several times.
5. Before putting it back in the cooler, allow it to dry completely.
6. Replace it and secure it with the locking screws.
Note: do not use the cooler if the grille is not in place.
Cleaning the housing
Before cleaning the cooler, switch it off. Wait a few minutes and unplug it from the mains.
- Wipe the appliance with a slightly damp cloth and then dry it with another cloth.
- Never use benzene alcohol or solvents to clean the appliance.
- Do not spray insecticides or similar products on the cooler.
Emptying the water tank
It is recommended to empty and clean the water tank every 2-3 weeks (if the cooler has been
used). Carry out the following steps:
1. Remove the water tank from the appliance.
2. Remove the water pump by pulling it out of the safety bracket.
3. Clean the inside and outside of the tank with a soft cloth previously soaked in soapy water.
4. Then, rinse with lukewarm water.
5. Allow the tank to dry out completely and place the water pump back in its holder before
putting it back in the cooler.
Cleaning mineral deposits
To reduce/remove mineral deposit build-up in the water tank, you can follow the
recommendations below:
- Use demineralised or distilled water.
- Follow the following procedure on both water tanks at least once a month:
Make sure the cooler is unplugged.
o
o Use specific descaling liquid for cleaning coolers and follow the instructions on the liquid.
Make sure that the inside of the tank is clean and dry before reassembly.
o
Replace the water tank and store the cooler in a safe and dry place.
o
36
ENERGYSILENCE 3500 COOL COMPACT SMART