GE GEH50DEED Manual Del Propietario E Instalación página 7

About the water tern erature settin
. GEA liances.com
Temperature setpoint:
Safety, energy conservation and hot water capacity are factors
to be considered when selecting the water temperature setting
of the water heater. To comply with safety regulations,the water
temperature setpoint isfactory set at 120°F(49°C). This is the
recommended starting temperature setting.
NOTE," A ccording to USDept of Energy,the average residential
water heater in the USis set at 135°F(57°C).GEGeoSpring T"
Hybrid Water Heater'senergy savingsclaims are based on a
135°F(57°C) t emperature setting. The water temperature setpoint
can be raised from the factory setting of 120°Fto 135°F(49°Cto
57°C)without sacrificing the claimed energy savings. If a lower
temperature setting than 135°F(57°C)is used,greater savings in
energy and operating costs may be achieved.
See "ToAdjust the Temperature" section to change the water
heater's temperature.
Hot water capacity."
If more hot water capacity is desired, increasing the temperature
from 120°Fto 135°F(49°Cto 57°C)will enable the same tank of hot
water to last about 25% longer because more cold water is mixed
in at the shower or faucet.
Time/Temperature Relationship in Scalds
Temperature ' Time to Producea Serious Burn)
120°F (49°C) Hore than 5 minutes
125°F (52°C) 1-1/2 to 2 minutes
130°F (44°C) About 30 seconds
135°F (57°C) About 10 seconds
140°F (60°C) Less than 5 seconds
145°F (63°C) Less than 3 seconds
150°F (66°C) About 1-1/2 seconds
155°F (68°C) About i second
Tablecourtesyof Shriners BurnInstitute
Risk of Scalding Reminder."
Water temperatures above 125°F(52°C) c an cause severe burns
or death from scalding. Be sure to read and follow the warnings
outlined in this manual and on the label on the water heater. This
label is located on the water heater near the upper element access
panel.
See "Time/TemperatureRelationshipin Scalds"below as a guide in
determining the proper water temperature for your home.
Mixing-valves."
Hixing valves for reducing point-of-use water temperature by
mixing hot and cold water in branch water linesare available.
Contact a licensed plumber or the local plumbing authority for
further information.
^_ DA NGER: There is a hot water scald potential if the
water temperature is set too high. Households with small children,
disabled, or elderly persons may require a 120°F(49°C)or lower
thermostat setting to prevent contact with HOT water.
To Adjust the Temperature
Follow these steps:
1. Press the UP or DOWN arrow on the control panel key pad
to desired temperature,
2. Press ENTERto accept the new setting.
Note:To change between °F and °C, press and hold MODE.
h*
ADANGER:
Thereis a not Water scald Potential
if the water temperature is set too high. 120°F(49°C)is the
recommended starting point for water temperature setting,
but it can be adjusted to any temperature between 100°Fand
140°F(38°Cand 60°C).
GeoSpring
f
o HEAT PUMP IO.Lvl \ /
o HYBRID
o HIGH DEMAND/BOOST
o ELECTRIC/STANDARDIFA.OFF1
O
VACATION
Hold for Hold to Override Hold to
°F/°C PS-Power Sever Reset
,J
/