Publicidad
Idiomas disponibles
Idiomas disponibles
Notice:
Max. developed length of the exhaust duct is 1,500mm. It's better to shorten it while use and keep it
horizontal while installation.
Cooling mode
When the A/C enters cooling mode automatically or cooling mode is selected after power ON,
⚫
the cooling indicator lamp lights up.
Press Up/Down key to adjust setting temperature (16℃~30℃).
⚫
Press Speed key to choose High/Mid/Low speed.
⚫
Fan mode
When pressing mode key or choosing Fan mode by pressing the remote controller, the wind
⚫
indicator lamp lights up.
Press Speed key to choose High/Mid/Low speed.
⚫
Temperature can't be set.
⚫
Dehumidification mode
When pressing mode key or choosing dehumidification mode by
⚫
pressing the remote controller, the dehumidification indicator lamp
lights up.
Remove the dehumidification water wedge, insert water manifold,
⚫
place the other end of the water manifold into the water vessel or
drainage passage, as shown in the right figure.
After entering the dehumidification mode, if room tempearture≥17℃
⚫
(62℉), the compressor is ON. Then control as follows: when room
temperature ≤15℃ (59℉)
the compressor is OFF; when temperature increases to room temperature≥17℃, the compressor
is started again (in order to protect the compressor, it will be restarted 3min. later).
In dehumidification mode, the fan is defaulted to run at low speed, and wind speed can't be
⚫
adjusted.
Temperature can't be set. （Note : when use dehumidify function, should remove exit pipe
⚫
components, otherwise, it will cause worse dehumidify performance, and appear "FL"
water full alarm ）
Timer mode
In standby state, press the Timer key to set ON time. Press Up and Down keys to set ON time
⚫
(1~24H), and the timer indicator lamp lights up.
In ON state, pressure the timer key to set OFF time. Press Up and Down keys to set OFF time
⚫
(1~24H), and the timer indicator lamp lights up.
OPERATION METHOD
S. 117
Publicidad
