Descargar Imprimir esta página

MoMi MIYA Manual De Usuario página 10

Ocultar thumbs Ver también para MIYA:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 34
wheelchair. Press the headband into the connectors until you hear a click. Pull the headband to
make sure that it is properly seated (picture 10a). To take out the bar press the buttons located on
the underside of the bar (Fig.10b)
PRODUCT FEATURES:
• The canopy can be adjusted to many different positions as needed. The canopy can be enlarged by
an additional part by unfastening the zip fastener and pulling the canopy forward.
• To adjust the footrest, press both the adjustment buttons on both sides of the footrest (picture 12).
• The backrest of the stroller has three points of adjustment. To change the angle of inclination of the
backrest hold the adjustment button located on the back of the backrest as shown in fig 13 and then
press it and push the backrest up and down.
• The product is equipped with 5-point seat belts. To buckle the safety belts in, place both shoulder
strap buckles in the side strap buckles.
The straps can be adjusted to fit the child properly, but be careful that the child is not too tightly
compressed and can breathe freely. When fastening the seatbelts, make sure that the child's hands
are not near the buckle.
• The straps of the safety belts have a 3-step height adjustment to better adapt them to the child's
needs. To change the height, unclip the buckle by sliding it from the bottom of the backrest with one
hand and pull it out on the other side. Select the height at which you want to mount the belts, and
then pass the buckle through the hole in the fabric and pull it through the backrest until it locks on
its back (fig. 17a-17c).
ATTENTION! Check that the seat belt is properly locked on the back of the seatback.
WARNING - Always use the restraint system.
• This stroller is equipped with a foot parking brake on the rear axle. Press the brake pedal downwards
so that the brake is activated. Unlocking takes place after lifting the pedal up (fig. 18).
PRODUCT FOLDING:
To fold the stroller, fold the canopy first and then unblock the double lock located on the push handle – pull
the button located on the top of the block to the left and simultaneously press the button located under
the push handle (Fig. 14). After releasing the block push the handle down and the stroller will fold up. The
locking latch (Fig. 15) will automatically block – a distinctive clicking sound means the latch was blocked
correctly.
CLEANING AND MAINTENANCE:
• Periodically check the technical condition of the trolley for damage or missing parts.
• Stop using the wheelchair if any part is missing or damaged.
• The product should be cleaned with a damp cloth with a mild soap solution.
• If the product frame has been exposed to salt solution, clean the product as soon as possible with a
damp cloth with a soap solution.
• If the cart is wet, leave it unfolded until it is dry to prevent mold growth.
• Never leave the stroller in a humid or hot environment.
Thank you for reading the manual. Please keep it for future reference.
10
EN

Publicidad

loading