MoMi MIYA Manual De Usuario página 9

devices are correctly engaged before use.
• This product is not suitable for running or skating.
• The product is intended for children from 0 months old up to 22 kg of weight or 4 years old whiche-
ver comes first.
• We recommend using the most reclined (lowest) position of the backrest for newborn babies.
• The parking device shall be engaged when placing and removing the children.
• Maximum load on the basket is 2 kg.
• Maximum load of a cup holder is 0,5 kg.
• Any additional load attached to the handle, on the back of the backrest and on the sides of the
vehicle will affect the stability of the vehicle.
• The product is intended for the transport of one child at a time.
• Only use parts and accessories that have been supplied or recommended by the manufacturer. Do
not use accessories which are not approved by the manufacturer.
• Do not place the product near an open flame or other heat sources.
• Regularly check the technical condition of the stroller.
• Do not use the stroller on stairs.
• Additional luggage put in the stroller may lead to the loss of its stability.
• Do not use the product if you are in any doubt about the correct operation of the pram or its safety.
COMPONENTS:
A. Folding buton
B. Canopy with extension part
C. Push handle
D. Bumper
E. Seat belts
F. Adjustable backrest
G. Textile basket
PRODUCT ASSEMBLY:
1. Before assembling, make sure that nothing is missing .
2. Place the frame on a flat surface and unlock the frame lock button (as shown at picture 2).
3. Grab the handle and pull it upwards to unfold the frame (as shown at picture 3).
4. To install the front wheels, insert them into the holes in the front of the frame until you hear a click,
then you can be sure that the wheels are properly and securely assembled (as shown at picture 4).
To remove the front wheels, press the quick release button (as shown at picture 5).
The button on the back of the front wheel allows to block them (Fig. 6). To block manoeuvring, pull
the button down.
5. To install the rear axle with brake, insert it in the plastic holes at both ends of the brake into the
metal tube of the frame until you hear a click (as shown at picture 7)
6. Install the rear wheels by inserting them into the holes on the rear axle until you hear a click, then
you are sure that the wheels are properly and securely assembed (as shown at picture 8). To remove
the rear wheels, press the lock button and pull the wheels out of the holes (as shown at picture 9).
7. To install the seat bar, grasp it with both hands and align it with the connectors on both sides of the
EN
H. Rear wheel brake
I. Rear wheels
J. Footrest
K. Front wheels
L. Accessories: Mosquito net, rain cover, cup
holder, leg cover
9