Publicidad
Idiomas disponibles
Idiomas disponibles
Note: The lifetime of the absorbent cotton is about 6 months.
Exceeding the service life will greatly reduce the filtration ability.
Air exchange with activated charcoal filter
(Fig.9 on page 8)
We recommend that you replace the filter in every 6 months. To
replace the filter just 90° to the left or right and remove / insert.
Note: The lifetime of the filter is about 6 months. Exceeding the
service life will greatly reduce the filtration ability.
UV lamp replacement
204962, 221433 (Fig. 10a and 10b on page 9)
1. Remove the stainless-steel cover under the water container.
(Fig. 10a)
2. Twist off the UV lamp for replacement. (Fig. 10b)
221426 (Fig. 10c - 10e on page 10)
1. Remove the screws on top inside the cabinet. (Fig. 10c)
2. Pull out the UV lamp module and disconnect the plugs. (Fig.
10d)
3. Remove the UV lamp cover (32), then replace the UV lamp.
(Fig. 10e)
Note: The lifetime of the UVC is about 8 months. Exceeding the
service life will greatly reduce the disinfection ability. To keep
the best UV performance, please change the UV lamp every
2.5month.
Defrost system
• The appliance has an automatic circulation defrosting system
design. The appliance can automatically defrost when the
compressor is stopped and timing. The frost water is auto-
matically discharged from the storage area of the ripening
machine. The water condensed in the container is converted
into heat or evaporation by the compressor , The remaining
water to maintain the humidity in the cabinet.
• All units are equipped with a double layers Low-E glass door
that has a third internal acrylic layer to minimize condensa-
tion on the glass door.
• The appliance is not totally sealed; fresh air admission is per-
mitted through the drainpipe.
Notes: During the refrigerating cycle, heat is given off and dis-
perses through the external surfaces of the appliance. Avoid
touching the surfaces during those cycles.
Humidification system description
This product has automatic humidification function. The hu-
midification system is inside the fan cover. If there is no main-
tenance requirement, it is forbidden to open and pull out! This
product has a watering reminder function. When the water tank
is short of water, there will be a buzzer prompt, and the display
window will display " E5" indicates a water shortage fault, and
the light will flash when this fault occurs.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Clean the inside of container with a non-abrasive detergent
and rinse with clean water.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for cleaning.
Do not use petrol or solvents!
• No parts are dishwasher safe.
Parts
How to clean
All accessories
• Soak in warm, soapy water
such as rack
for about 10 to 20 minutes.
holders, etc.
• Rinse under running water
thoroughly.
External glass
• Wipe clean with a soft cloth
surfaces
and a little neutral deter-
gent. Make sure no water
or moisture enters inside
the of the appliance.
Interior glass
• Remove any food deposits.
surfaces
• Wipe clean with a soft cloth
and a little mild detergent.
Glass door
Make sure no water or
moisture enters inside the
of the appliance.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never in-
cline more than 45°.
GB
Remark
Dry all parts
well at last.
17
Publicidad
