neno Bella Twin Manual Del Usuario página 17

the milk to body temperature.
4. Do not add freshly drained milk to previously frozen milk if the amount of
fresh milk exceeds the amount of previously frozen milk.
5. It is recommended that you breastfeed before you start feeding your baby
with a bottle.
6. Always check the bottle, teat and other components before and after each
feeding. If the teat is damaged, stop using it immediately.
7. To avoid the risk of strangulation, test the strength of the soother by pulling
gently on its protruding part.
8. Do not try to enlarge the opening of the teat.
9. Infants should not be bottle fed without adult supervision.
10. The teat of the bottle should not be used as a soother for the baby.
10. LONG-TERM STORAGE
1. The breast pump has a built-in battery. To protect against damage, the devi-
ce goes into storage mode after a long period of inactivity. To disable storage
mode, connect the device to power and charge it for 2 hours. Before you put
the breast pump down for an extended period of time, make sure that:
a. All parts of the breast pump are clean.
b. You cleaned the pumping device.
c. The device battery is fully charged.
11. FAQ
1. The device does not start: make sure that the breast pump is connected to a
working electrical outlet. If the breast pump has no power source, its display
will not turn on and no error message will appear.
2. The device does not pump when switched on: make sure the device has a
charged battery or is connected to the power supply.
3. No/poor suction: Make sure all parts of the breast pump are correctly
positioned. Take the breast pump apart and make sure all parts are clean
and undamaged. Reassemble the breast pump according to the instructions
in the
instructions in the Lactator Assembly section. When pumping, make sure the
entire surface of the funnel is pressed against the breast.
4. More milk has come out of your breast than the bottle can hold: turn off
the pump and unplug it. Use a moist (not wet) cloth to wipe the breast
pump. Wash the parts of the breast pump that contain milk according to the
instructions in the CLEANING AND DISINFECTING section. When all parts of
the machine are dry, reassemble.
12. SPECIFICATION
Input power: 110-240V 50-60Hz | Output power: 5V 1A | Battery capacity: 3.7V
17