Sharp CP-AWS2001 Guia De Inicio Rapido página 5

CE and UKCA statement:
• Hereby, Sharp Consumer Electronics Poland sp. z o.o.
declares that this audio device is in compliance with the
essential requirements and other relevant provisions
of RED Directive 2014/53/EU and UK Radio Equipment
Regulations 2017.
• The full CE text and UKCA declaration of conformity
are available at sharpconsumer.eu and then entering
download section of your model and choosing
"Declaration of Conformity".
Compatibility warning
TV compatibility
• These speakers work exclusively with AQUOS Wireless
Surround (AWS) enabled SHARP TV's only. Please
check you have the correct model of SHARP TV. To find
compatible models, scan the QR code at the beginning of
this user guide.
Wireless signal
• You will need to be connected to a 5GHz Wi-Fi network
for the best wireless speaker performance. If a 5G Wi-Fi
network is not available, a 2.4GHz network can be used.
A 2.4GHz network is more prone to interference and may
impact wireless speaker performance.
The 5 GHz WLAN function of this equipment may only be
operated indoors.
WLAN max transmitter power:
100 mW at 2,400 GHz – 2,4835 GHz
100 mW at 5,150 GHz – 5,250 GHz
100 mW at 5,250 GHz – 5,350 GHz
100 mW at 5,470 GHz – 5,730 GHz
100 mW at 5,735 GHz – 5,835 GHz
BT max transmitter power: 10 mW at 2,402 GHz – 2,480
GHz.
What is included in the box:
• CP-AWS2001 rear surround speaker x2
• Power adapter with type C (EU 2 pin) and G (UK 3 pin)
inserts x2
• Wall-mount adapter x2 (brackets not inc.)
• User documentation
Inputs/outputs
(Refer to 1 on page 3).
1. LED Indicator
• Standby / Disconnected - Red
• Firmware update failed - Red (flashing)
• Pairing - Green (flashing)
• Connected - Green
• Bluetooth Connected - Blue
• Firmware update in progress - Yellow
2. Pair button
PAIR
• Short press to enter pairing mode.
• Long press (>5 seconds) to reset
3. Upgrade Button
(For firmware upgrade use only)
4. Micro USB
(For firmware upgrade use only)
5. Power cable clip
6. DC IN socket
Socket for connecting power adapter (DC 12V/1.5A)
7. Wall mount screw/screw hole cover location.
Initial set up
Placement and mounting
To enjoy immersive audio from your Sharp AWS enabled
TV, place the rear surround speakers behind your preferred
listening position, ideally at ear level. The speakers can be
placed on speaker stands, furniture or you can mount the
speakers to a suitable wall.
1. Place the surround speakers upright on the speaker
stands/furniture at ear level behind your preferred
listening position (Refer to
choose to place the surround speakers like this, ensure
the rubber screw hole cover is in place (Refer to
on page 3).
2. Place the surround speakers on the wall or speaker
stands that allow mounting by screw with wall mount
brackets. (Refer to
NOTE:
ū Installation must be carried out by qualified personnel
only. Incorrect assembly can result in severe personal injury
and property damage (if you intend to install this product
yourself, you must check for installations such as electrical
wiring and plumbing that may be buried inside the wall). It is
the installer's responsibility to verify that the wall will safely
support the total load of the unit and wall brackets.
ū Additional tools (not included) are required for the
installation.
EN
4 on page 3). If you
5 on page 3).
2