Troubleshooting
Problem
The appliance
does not
operate.
The usage time gets short.
The appliance stops during
operation.
Cannot
remove hair.
PB015615 - EL8A-3A-2A
_(01GB)_11-07-17.indd 21
Possible cause
It is not charged.
The switch is turned
ON with the adaptor
connected to the
household outlet.
The skin protector or
When
discs are deformed,
epilating
cracked, or damaged.
Hair dust has
accumulated.
When
epilating
Shower gel has
or shaving
adhered to the discs
and blade.
When
The frame is not
caring for
securely attached.
feet
The appliance is used
with approximately
5 °C or lower.
The appliance is
pressed against skin
too hard.
Not charged fully.
The appliance is
pressed against skin
too hard.
Not charged fully.
The appliance is used
on long hair.
When
The way the unit is
epilating
applied or moved is
not correct.
Action
Fully charge the appliance.
Charging is only
possible when
connected to the
household outlet.
Disconnect from the
household outlet before
use.
Request repair at an
authorized service centre.
Clean the hair dust.
Wash it off by soaking in
warm water.
Reattach it.
Use the appliance in an
ambient temperature
approximately 5 °C or
higher.
Contact to skin with
gentle force.
Fully charge the appliance.
Contact to skin with
gentle force.
Fully charge the appliance.
Use on hair approximately
2 to 3 mm long.
Refer to page 17.
2017/11/7 11:11:23
21