Installation
STEP 4 Install the ice maker and connect the water line (Applicable models only)
If your model supports the optional Auto Ice Maker (part type: RA-TIMO63PP/AA)
installation, you can purchase and install the Auto Ice Maker separately.
• To purchase the Auto Ice Maker, visit the Samsung website (www.samsung.com) or
contact your retailer.
• To use the ice maker, you must connect the water line to it. For the ice maker to operate
properly, a water pressure of 20 - 125 psi (138 - 862 kPa) is required.
• For detailed instructions on the installation of the Auto Ice Maker, refer to the
installation manual enclosed with the Auto Ice Maker kit.
CAUTION
Do not install or uninstall the Auto Ice Maker while the refrigerator is operating.
STEP 5 Connect the water line (Applicable models only)
You must connect a water line from the main water supply to your refrigerator to use the
water dispenser or the auto ice maker.
CAUTION
• To prevent burns and product damage, do not connect the water line to a hot water
source.
• Do not install the water line in areas where temperatures fall below the freezing point.
• If water is not supplied to the refrigerator, make sure to turn the ice maker off.
NOTE
• All installations must be in accordance with local plumbing code requirements.
• To purchase additional water filters, contact the manufacturer or the retailer of the filter.
- We recommend using a kit that contains copper tubing and a 6 mm (
nut.
- The water filter must be replaced as instructed by the manufacturer or the retailer.
• Leaving the water line disconnected may cause the water valve to produce a buzzing
sound over time.
Water pressure
The water pressure supplied to the refrigerator must meet the following requirements:
20 psi (138 kPa)
If the refrigerator is installed in an area where minimum water pressure cannot be met,
you can install a booster pump to compensate for the low water pressure.
20
English
Minimum
/
") compression
1
4
Maximum
125 psi (862 kPa)