Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. TECHNICAL DATA
Model
Viewing Area
Cartridge Size
Arc Sensor
UV/IR Protection
Light State
Dark State
Sensitivity Control
Switch Time
Delay Control
Power Supply
TIG AMP Rating
Operating Temperature
Storing Temperature
Grinding Functions
Low Volume Alarm
ADF Self Check
Welding process
3. operation
HEADGEAR ADJUSTMENT
93x43mm
110x90x9mm
2
UP to shade DIN 16 at all times
DIN 4
Variable Shade DIN 9-13
Variable adjusted by internal knob
1/25.000sec
0.1-1.0sec Variable adjusted by internal knob
Solar cells +Replaceable 1*CR2450 lithium battery
10amps(DC/AC)
-5°C to +55°C
-20°C to +70°C
Yes
Yes
Yes
MMA, MIG/MAG,TIG
1. Adjust the headgear diameter with the twist knob on the back. The knob is locked
until pushed in. Once unlocked, twist clockwise to tighten and counterclockwise to
loosen.
2. Adjust the height by snapping the pin into the hole to lock securely in place.
3. To adjust the viewing angle, loosen the knob on both sides of the helmet and chan-
ge angle locker to the desired tilt position (5 selection and positioned in the middle by
default). Once achieving the desire angle, tighten the knobs until snug. The helmet
should still swing up, but it should not drift downward when in place for welding.
4. To adjust the distance between the user's face and ADF, loosen the knobs on both
sides of the helmet until the headband can move back and forth freely, reposition the
headband at one of the 3 slots as desired (The headband is positioned in the middle
electronic mask
4
Publicidad
