Omega Mascara Electronica Manual De Instrucciones página 13

EN
by default). This should be done one side at a time and both sides should be located at the same position for proper
auto-darkening filter operation..
SHADE CONTROL
This model shade No. is available from DIN 9 to DIN 13, user should set the shade state in corresponding welding
Amperes in different application.
Shade Guide Table
SENSITIVITY CONTROL
The sensitivity is variable adjusted by internal knob.
DELAY CONTROL
When welding ceases, the viewing window automatically changes from dark back to light but with a pre-set delay to
compensate. The delay time can be adjusted by internal knob from 0.1 sec to 1.0 sec.
4. maINTENANCE
FRONT COVER LENS REPLACEMENT
Replace the front cover lens if it is damaged (cracked, scratched, pitted or dirty). Place your finger or thumb into the
recess and flex the inside cover lens upwards until it releases from one edge. Then remove any protective film before
installing the new one.
INSIDE COVER LENS REPLACEMENT
Replace the inside cover lens if it is damaged (cracked, scratched, pitted or dirty). Place your finger or thumb into the
recess and flex the inside cover lens upwards until it releases from one edge. Then remove any protective film before
installing the new one.
5