CRAFT+MAIN JETCOAT GFS603678-CO Manual Del Usuario página 11

INSTALLATION PROCEDURE / STEP 7
INSTALL LEFT WALL PANEL
7
Important Note: The arrows on the label on the back of each panel indicate the TOP of the Panel.
1. Locate the panel labeled (4) Left Side Panel and lay it down on a flat surface.
2. Based on your measurements from Step 1 (Measuring) cut the panel to the appropriate size and
make any required plumbing cut-outs according to the instructions in Step 2 (Cutting).
3. Apply the double-sided tape and construction adhesive as explained in Step 3.
4. Peel o back of double-sided tape from the back of the beveled edge wall panel.
5. Position the panel at approximately 30 degrees, push the panel edge into the corner and then
carefully push the panel back towards the wall.
6. Press against the wall smoothing out any air bubbles along the entire area and then lightly tap on
wall panel with a rubber mallet from top to bottom to ensure it is tightly connected to the wall.
1
4
- 10 -
2