Publicidad
Idiomas disponibles
Idiomas disponibles
EN CFX2 28, CFX2 37, CFX2 45, CFX2 57
3. Re-assemble the plug in reverse order.
Replacing the light PCB
NOTICE! Damage hazard
The light PCB may only be replaced by the manufacturer, a service agent service or a similarly qualified
person in order to avoid hazard.
10 Cleaning and maintenance
CAUTION! Electrocution hazard
Ensure that the cooling device is disconnected from the power supply before any cleaning or mainte-
nance work.
NOTICE! Damage hazard
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning.
Occasionally clean the device interior and exterior with a damp cloth.
Ensure that the air inlet and outlet vents on the cooling device are free of any dust and dirt, so that heat can be
released and the cooling device is not damaged.
11 Troubleshooting
Problem
The cooler does not operate. The
power LED does not light up.
The power LED lights up orange, the
error code E 01 is displayed, and the
cooler is not cooling even though the
plug is plugged in.
18
Possible cause
No voltage is detected at the DC sock-
et.
No voltage is detected at the AC sock-
et.
The AC fuse is defective.
The integrated mains adapter is defec-
tive.
The battery monitor is set too high.
The battery monitor is set too low.
Suggested remedy
Activate the ignition of the vehi-
cle.
Use another plug socket.
Replace the AC fuse, see
ing the AC fuse
on page 17.
Contact an authorized service
agent.
1.
Set the battery monitor to a lower
mode (see
Using the battery mon
itor
on page 14).
2.
Test the starting battery.
3.
If necessarry, charge the starting
battery.
Follow the manufacturer's in-
structions.
1.
Set the battery monitor to a high-
er mode (see
Using the battery
monitor
on page 14).
2.
Test the starting battery.
Replac
Publicidad
