Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
When operating the cooler from the
DC outlet: The ignition is on and the
cooler does not operate. The power
LED does not light up.
The display displays an error code and
the cooler does not cool (see
codes
on page 19).
Error codes
NOTE If one of the error codes E 02 to E 07 occurs, contact an authorized service agent.
Error code
Description
Low voltage/overvoltage
E 01
Fan overcurrent
E 02
Compressor start failed
E 03
Compressor speed low
E 04
Controller overheated
E 05
NTC open circuit
E 06
NTC short circuit
E 07
12 Warranty
LIMITED WARRANTY AVAILABLE AT DOMETIC.COM/WARRANTY.
IF YOU HAVE QUESTIONS OR TO OBTAIN A COPY OF THE LIMITED WARRANTY FREE OF CHARGE, CONTACT
THE DOMETIC WARRANTY DEPARTMENT:
DOMETIC CORPORATION
Possible cause
The DC plug is not connected correct-
ly.
The DC socket is dirty. This leads to
poor electrical contact.
The DC plug fuse has blown.
The DC fuse inside the cooler has
blown.
The vehicle DC outlet fuse has blown.
The cooler has switched off due to an
Error
internal fault.
CFX2 28, CFX2 37, CFX2 45, CFX2 57 EN
Suggested remedy
3.
If necessarry, charge the starting
battery.
Follow the manufacturer's in-
structions.
Reconnect the DC plug.
Clean the DC outlet.
Follow the manufacturer's in-
structions.
Replace the DC plug fuse, see
chapter
fuse
Contact an authorized service
agent.
Replace the vehicle DC outlet
fuse.
Follow the manufacturer's in-
structions.
Contact an authorized service
agent.
Replacing the DC plug
on page 17.
19
Publicidad
