Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE
LUBRICATION
Use only high quality detergent oil rated
with API service classification
SF-SJ.
Select the oil's SAE viscosity grade
according to your expected
operating
tem
-20
0
30
60
80
100
-30
-20
-10
0
10
20
30
40
TEMPERATURE
RANGE ANTICIPATED
BEFORE NEXT OIL CHANGE
NOTE:
Although
multi-viscosity
oils
(5W30,
10W30
etc.) improve starting in
cold weather,
these multi-viscosity
oils
will result in increased oil consumption
when used above 32°F.
Check your
engine oil level more frequently
to avoid
possible engine damage
from running
low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
unit is not used for 25 hours in one year.
Check the crankcase
oil level before
starting the engine and after each five (5)
hours of continuous
use. Tighten oil plug
securely each time you check the oil
level.
TO CHANGE
ENGINE
OIL
NOTE:
Before tipping tdmmer
to drain
oil, drain fuel tank by running engine
until fuel tank is empty.
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip trimmer on its side as shown and
drain oil into a suitable container.
Rock trimmer back and forth to
remove any oil trapped inside of
engine.
4. Wipe off any spilled oil from trimmer or
side of engine.
5.
Fill engine with oil (See "ADD OIL" in
the Operation section of this manual).
6.
Replace engine oil cap.
7.
Reconnect spark plug wire to spark
plug.
Container
11
Publicidad
