Publicidad
Idiomas disponibles
Idiomas disponibles
Read these instructions and this manual in its
entirety before you attempt to assemble or
operate your new trimmer.
IMPORTANT:
This trimmer is shipped
WITHOUT OIL OR GASOLINE in the engine.
Your new trimmer has been assembled at the
factory with the exception of those parts left
unassambled for shipping purposes. All parts
such as nuts, washers, bolts, etc., necessary
to complete the assembly have been placed
in the parts bag. To ensure safe and proper
operation of your trimmer, all parts and
hardware you assemble must be tightened
securely. Use the correct tools as necessary
to ensure proper tightness.
When right hand (RH) or left hand (LH) is
mentioned
in this manual, it means when
you are in the operating position (stand-
ing behind the handle).
Loose Parts Packed Separately
Bottle of oil
Trimmer Lines
(2) sets
(0.155 diameter
x 18.75 inches long)
TO REMOVE
TRIMMER
FROM CARTON
1, Remove
loose parts included with
trimmer.
2. Cut down two end corners of carton
and lay end panel down flat.
3.
Remove
all packing materials.
4.
Roll trimmer out of carton and check
carton thoroughly for additional loose
parts.
HOWTO
SET UPYOUR
TRIMMER
TO UNFOLD HANDLE
IMPORTANT:
Unfold handle carefully so as
not to pinch or damage control cables.
1. Loosen
handle
knob enough to allow
upper handle to be unfolded
from the
shipping
position.
2.
Raise upper handle
section
into place
on lower
handle
and tighten
handle
knob.
3.
Remove
handle
padding
holding
trimmer
head control
bar to upper
handle.
Your trimmer
handle can be adjusted
for
your trimming
comfort.
Refer to "ADJUST
HANDLE"
in the Service
and Adjustments
section
of this manual.
handle
LIFT UP
knob
handle
5
Publicidad
