Jimmy HW9 Pro Max Manual De Instrucciones página 9

Operation of machine
Step on floorhead and push back the handle to release
mainbody to tilt state, press the on/off button, default is
in Auto mode, press the mode button to switch among
floor mode, carpet mode and Auto mode, accompanied
by English voice reminding. Press the on/off button
again, the voice reminds "Machine turning off", the main
motor will run for 2 seconds and then the machine stops
working. (Fig 9)
Note:
1. When cleaning carpet, please clean the floorhead
first (refer to " Cleaning and Maintenance, Floorhead
Cleaning" for details) and propose to change to
carpet brush (Carpet brush can be purchased from
JIMMY distributors).
2. Under carpet mode, keep pressing mode button for
5 seconds,product will work in maximum power and
provide stronger cleaning performance.
3. When the battery power is lower than 20%, it cannot
be switched to Carpet mode.
In Auto mode, the machine power changes automatically
basing on how much dirty water or dust is detected. And
LED light colour changes accordingly. The more dirty
water or dust is detected, the more red lights. And the
less dirty water or dust is detected, the more blue lights.
Water spray function
When upright vacuum cleaner is working, press the water spray button, the auto water spray function is
open by default. LED screen will show auto spray indicator and clean water will be sprayed to brushroll
automatically. (Fig 10-1). To turn off auto water spray function, keep pressing the self cleaning button for over
3 seconds when product is on. To turn on auto water spray function again, keep pressing the self cleaning
button for over 3 seconds when product is on.(Fig 10-2)
If floor is very dirty, you can choose to spray more water to floor by using manual water spray function to
improve floor washing effect. With the machine turned on, press manual water spray button, spray mouth
sprays fan-shaped water; release the water spray button to stop spraying water. Manual water spray function
can be activated no matter whether auto water spray function is turned on or off. (Fig 10-3)
Keep pressing self-cleaning button for 3s to turn on or turn off brushroll auto water spray function.
Note:
1. The manual water spray button cannot be used with the on/off button or the mode button at the same time.
2. It is recommended to use carpet mode when there is heavy pollution or water stain.
3. When cleaning carpet, please turn off auto water spray function.
4. Please use the low-foam cleaning solution with this product for cleaning, do not put the easy foaming
cleaning solution into the clean water tank for use, otherwise more foam will be generated during use,
which may penetrate into the machine and cause danger.
Machine charging
Connect the power cord to the power supply, put the product into the charging base to start charging. The
display screen will turn off when fully charged.(Fig 11)
Note:
1. Before the first use, please fully charge the battery pack, and before the second charge, please empty the
battery to ensure the life of the battery pack.
9
10-1
Manual spray
button
10-3
Self cleaning/
Auto water
spray button
10-2
7