Silk’n FACETITE MINI Manual De Usuario página 17

6. Using energy level 1, place the product on the area you want
to treat. Make sure that it is in good contact with the skin. You
will feel a mild sensation of warmth.
7. Move the product in gentle massage-like motions on the area
you wish to treat. Progress slowly and carefully. Keep moving
the product ensuring that the 3 electrodes stay in full contact
with the skin as you treat the area.
8. With the product constantly in motion, treat each area for at
least 3-5 minutes.
9. Increase the energy level gradually. Using the highest energy
level will get the best results, but it's important that you set
the energy level that is comfortable for the area you are
treating.
You will feel the skin temperature increase as you increase the
energy level. It usually takes about 1 minute for the product to
reach the required temperature. During the treatment your
skin will get a little red. Don't worry; this is normal.
Stop immediately if you feel any discomfort.
10. Try to move the product slowly at first. If the treatment area
is hot and uncomfortable, try to move the product faster.
11. Clean the treated area: remove the Slider Gel residue off the
treatment surface , and clean the skin with warm water. Dry
the skin and apply moisturizing facial products.
8 Cleaning
NOTICE! RISK OF SHORT CIRCUIT!
• Do not immerse the product in water or
other liquids.
• Make sure that no water or other liquid
gets inside the housing.
17