Publicidad
Idiomas disponibles
Idiomas disponibles
Removing/Assembling the Doors
and Drawers
Removing the doors is always recommended when it is nec-
essary to move the refrigerator through a narrow opening.
WARNING
If your entrance door is too narrow for the refrigera-
tor to pass through, remove the refrigerator doors and
move the refrigerator sideways through the doorway.
Use two or more people to remove and install the
refrigerator doors. Failure to do so can result in back or
other injury.
Disconnect the electrical supply to the refrigerator
before installing. Failure to do so could result in serious
injury or death.
Do not put hands, feet or other objects into the air
vents, base grille, or bottom of the refrigerator. You
may be injured or receive an electrical shock.
Be careful when handling the hinge, base grille and
stopper. It may result in injury.
Remove food and bins from the doors and drawers
before detaching.
Removing the Left Refrigerator Door
1
The water supply is connected to the upper right part
of the rear surface of the refrigerator. Remove the ring
in the joint area. Hold the water supply connection and
gently push the Collet to detach the water supply line as
shown in
and
.
NOTE
Detachment of the water supply line is applicable only
when detaching the left refrigerator door.
Collet
(2)
(3)
(5)
(6)
(7)
(8)
2
Open the left door. Remove the top hinge cover screw (1).
Lift up the cover (2).
3
Remove the cover.
4
Pull out the tube (3).
5
Disconnect all wire harnesses (4).
6
Remove the grounding screw (5).
7
Rotate the hinge lever (6) counterclockwise. Lift the top
hinge (7) free of the hinge lever latch (8).
8
Lift the door from the middle hinge pin and remove the
door.
9
Place the door, inside facing up, on a non-scratching sur-
face.
CAUTION
When lifting the hinge free of the latch, be careful that
the door does not fall forward.
13
INSTALLATION
(1)
(4)
Publicidad
