HITWAY BK8 Manual página 11

6. Screw on the quick release rod nut as shown.
4. Install the Rear Fender
1. Use the No. 4 Allen key in the 16-in-1 tool to
remove the fender support screws pre-installed
on the left and right sides of the frame.
6
7. Adjust the direction of the wrench, adjust the
appropriate screw tightness, and tighten the
wrench upwards.
Note: During this process, ensure that the front
wheel is in the center of the front fork tube. If
there is any deviation, please loosen the lever to
adjust the position of the front wheel, and then
lock the lever.
-8-
7
1