Publicidad
PROCEDURE FOR TEMPERATURE CONTROL
1. Heat display symbol
2. Show the actual temperature in the furnace
3. Display the set temperature
4. Heat preservation display symbol
5. U button to set the temperature (After pressing the button, the setting
temperature will blink.)
6.Add temperature (Display setting temperature flicker to add temperature)
7. Reduce temperature (Display setting temperature flicker to reduce
temperature.)
8. Start heating/Confirm setting temperature
Procedure:
1. The temperature on the display is the actual temperature inside the
furnace.
2. Press the key U, the temperature number under the display will flash.
When flashing, it means the temperature can be set.
3. Press the key
to adjust the required temperature Short press
the
number will progressively increase by 1 degree, long press
the number
will speedily increase Short press
the number will progressively
decrease by 1 degree, long press
the number will speedily decrease.
4. Press the key P to confirm the setting temperature.
5. Upside the display, the symbol
means heating and insulation.Upside
the display, the symbol
flashing means increasing the temperature. Below
the display, the symbol
flashing means the holding temperature.
- 7 -
Publicidad
