Bosch Rexroth HQ 2/U Instrucciones De Montaje página 48

10/38 Notes on Safety
EMERGENCY STOPS,
malfunctions
During maintenance and
repair
During disposal
Bosch Rexroth AG, MIT: HQ 2/U, 3 842 546 879/2015-07
• An idle system is not a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
• After an EMERGENCY STOP or a malfunction, only switch on the system once
the cause of the fault has been determined and the error resolved.
• Make sure that there are no obstacles blocking access to maintenance
and inspection points.
• Perform the prescribed maintenance work at the intervals specifi ed
in section 10.3, Maintenance.
• Make sure that no lines, connectors, or components are disconnected
as long as the system is under pressure and voltage. Protect the system
against being switched on.
• Dispose of the product in accordance with the currently applicable national
regulations in your country.
2.7 Personal protective equipment
• Wear appropriate protective equipment (e.g. safety shoes, tight clothing,
hairnets for those with long hair) when working with the product.
As a plant operator, you are responsible for appropriate protective equipment
when working with the product.
All personal protective equipment must be intact.
2.8 Obligations of the system owner
• Before fi rst use or re-commissioning of a conveyor system, run a risk assessment
in accordance with DIN EN ISO 12100.
• Before initial commissioning ensure that there are no protruding or sharp-edged
parts that may endanger personnel working or moving in the area.
• Provide safety-related instructions to the operating personnel before fi rst use or
re-commissioning, and then in regular intervals.