Troubleshooting - VOSS.farming easyCUT go Instrucciones De Uso

de en fr
Cleaning the clipper head: The clipper head must also be cleaned regularly. First, remo-
ve the blades. Then loosen the two screws and remove the head from the drive. Now you
can thoroughly clean the head inside as well as all individual parts. If you reassemble it
afterwards, you should oil it again (lubrication is described in section 3).

9. TROUBLESHOOTING

Motor
Problem
Motor does not
run
Motor gets hot
Motor vibrates
Motor has a very
loud running noise
Motor runs very
slowly
Clipper head
Problem
Upper blade does
not move
Upper blade does
not move over
the entire running
surface
it nl sv
Cause
· switch or motor
defective
· cable defective
· battery empty
· air filter is blocked
· blade tension is too
high
· defective ball bearing
· blades or clipper
head run dry
· rotor runs out of
round
· bearings are worn
out
· fan wheel broken
· jammed bearing
· rotor or stator de-
fective
· clipper head knocked
out
· battery almost empty
Cause
· defective reduction
drive
· eccentric knocked out
· eccentric shaft de-
fective
es
Solution
· have checked /replaced by a
specialist
· check socket and fuse
· charge / change battery
· clean or replace air filter
· slightly loosen the tensioning nut;
if the blades still do not cut please
sharpen them
· have replaced by a specialist
workshop
· lubricate
· have it replaced by a specialist
workshop
· have it replaced by a specialist work-
shop
· have it replaced by a specialist work-
shop
· have it replaced by a specialist work-
shop
· charge / change battery
Solution
· have it replaced by a specialist
workshop
· have it replaced by a specialist
workshop
23