Publicidad
Idiomas disponibles
Idiomas disponibles
When
the metal parts are heated, they may expand and cause noise. >>> This is not a fault.
e
The mains fuse is defective or has tripped. >>> Check fuses in the fuse box. If necessary,
replace or reset them.
e
Product is not plugged into the (grounded) socket. >>> Check the plug connection.
e
Ifthe display does not light up when you switch the hob on again. >>> Disconnect the
appliance at the circuit breaker. Wait 20 seconds and then reconnect It.
e
Overheat protection is active. >>> Allow your hob to cool down.
e The cooking pot is not suitable. >>> Check your pot.
e
You have not placed the pot on the active cooking zone. >>> Check if there is a pot on the
cooking zone.
e
Your pot is not compatible with induction cooking. >>> Check if your cooking pot is compatible
with induction hob.
e
The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for
the cooking zone. >>> Choose a pot wide enough and center the pot on the cooking zone
properly.
Cookin
rheated
Allow
them
to cool down.
e
Cooking time for the selected cooking zone may be over. >>> You may set a new cooking time
or finish cooking.
e
Overheat protection is active. >>> Allow your hob to cool down.
e
An object may be covering the touch control panel. >>> Remove the object on the panel.
e
Your pot is not compatible with induction cooking. >>> Check if your cooking pot is compatible
with induction hob.
e
The cooking pot is not centered properly or the bottom surface of the pot is not wide enough for
the cooking zone. >>> Choose a pot wide enough and center the pot on the cooking zone
properly,
@
"Consult the Authorised Service Agent or the
dealer where you have purchased the
product if you can not remedy the trouble
although you have implemented the
instructions in this section. Never attempt to
repair a defective product yourself.
22/EN
Publicidad
