PRETUL CALI-20P Manual página 8

Vacuuming particles
• Connect a vacuum cleaner to the tool using the vacuum
cleaner connection to vacuum clean dust, saw dust or any
particle from the work piece.
Parallel guide installation
• Loose the Allen screws.
• Mount the parallel guide on to the base plate.
• Set the desired cutting width using the scale on the parallel
guide and the cutting mark on the base plate. The cutting
mark indicates the position of the saw blade.
• Tighten the Allen screws.
Start and operation control
• Press and hold the switch lock (B) to unlock the switch (A).
The switch lock prevents accidental switching on.
• Press the switch (A) for the tool to start operating.
• To stop the tool, release the switch (A).
• Press the laser switch (C) to turn it on or off.
• This switch also turns on the LED work light.
Variable speed
• The switch allows you to choose the appropriate speed for
each task. The tighter you press the switch, the faster the
saw will operate.
Adjust the cutting angle
• Loose the Allen screws using the included hex key.
• Adjust the baseplate to the desired position (0°- 45°).
• The sawing angle (bevel) can be read on the scale.
• Tighten the bolt, using the hex key. It ispossible to store
the hex key onto the machine.
Adjusting the pendulum action
The pendulum movement changes the cutting angle of the
jigsaw, enhancing cutting efficiency. It should be adjusted
with the jigsaw unloaded. The pendulum action switch can
be set to 4 positions:
0 - No pendulum action
I - Small pendulum action
II - Medium pendulum action
III - Large pendulum action
8
ENGLISH
Start up
B
A
Hex key
Base
• Soft material (wood, plastics etc.): set the pendulum
to level II or III.
• For a finer and cleaner saw cut,
use pendulum level 0 or I.
• Thin material, use pendulum level 0.
• Hard material (steel etc.): set the pendulum to level 0.
• Curves: set pendulum to level 0.
C
Screw for
base plate