PRETUL CALI-20P Manual página 9

Start up
Plunge cutting
WARNING
Plunge cutting may only be used on
soft materials such as wood, aerated concrete, gypsum
plaster boards, etc.
• Place the saw onto the workpiece and switch it on.
• Ensure that the bottom edge of the footplate rests on
the workpiece surface.
• Slowly saw into the workpiece at an angle, moving the
saw to a vertical position and continue to saw along the
cutting line.
• Switch the saw off and lift off the workpiece when the
work is complete.
Maintenance
Before cleaning and maintenance, always switch off the machine and remove the battery pack from the machine.
Cleaning and care
• Keep the tool free of dust.
• Never use water or chemical-based cleansing materials to
clean the tool.
• Clean only using a clean and dry cloth.
• Keep the ventilation slots always clean and free of
obstructions to guarantee the right cooling of the motor.
Service
The tool should only be serviced in a TRUPER
Authorized Service Center. Service and maintenance carried
out by non qualified people may be dangerous and could
cause severe personal injury. It also makes the product
Warranty void.
Environmental protection
Faulty and/or discarded electrical or
electronic apparatus have to be collected at the appropriate
recycling locations.
Compatibility with vacuum cleaners
ASP-03
CALI-20P
ASP-04 ASP-06
• Double-check the battery regularly to detect any type of
damage. Go to a TRUPER Authorized Service Center when
damaged to replace the battery.
Lubrication
• Apply regularly one drop of lubricant to the guide roller
to gain an adequate sliding of the saw blade while cutting.
ASP-5S ASP-5X
9
ENGLISH