Forno FFSGS6125-30 Manual De Instrucciones página 14

Oven rack rail installation
Installation
Disassemble
Electrical
Your range must be electrically grounded in accordance with local codes or, in the absence of local
codes, in accordance with the National Electrical Code (ANSI/NFPA 70, latest edition). In Canada,
electrical grounding must be in accordance with the current CSA C22.1 Canadian Electrical Code Part 1
and/or local codes.
The power supply must be the correct polarity. Reverse polarity will result in continuous sparking of
the electrodes, even after flame ignition. If there is any doubt as to whether the power supply has the
correct polarity or grounded, have it checked by a qualified electrician.
ELECTRICAL REQUIREMENTS
Electrical Supply
FFSGS6125-30 3600W
FFSGS6125-36 3600W
FFSGS6125-48 7025W
FFSGS6125-60 7200W
Service
Receptacle
Power Cord
WARNING
Electrical grounding Instructions:
for your protection against shock hazard and should be plugged directly into a properly grounded four-
prong receptacle.
Do not cut or remove the grounding pin from the plug.
Hang the rack to the side rails and push in slowly
Lift the rack up and pull out slowly until free of the side rails.
Grounded, 240 VAC, 60Hz
Grounded, 240 VAC, 60Hz
Grounded, 240 VAC, 60Hz
Grounded, 240 VAC, 60Hz
2/C 8AWG+2/C 10AWG
4-prong grounding-type
3.9' (1.2m)
This range is equipped with a four-prong (grounding) plug
14
Socket