Create Thera Matic Touch Manual De Instrucciones página 16

Milling dispenser
When to clean:
• It is recommended to check the milling dispenser once a week.
How to clean:
Method 1.
1. Press and hold the beans and espresso buttons into a cup for 2 seconds at the same time,
their corresponding indicators will flash.
2. Open the door and loosen the ground coffee in the brewing channel with a cleaning
brush, and then close the door when the ground coffee has fallen out.
3. Press and hold the bean dump button and the espresso one cup button at the same time
for at least one second, then their corresponding indicators will turn off and the door
will close.
Method 2.
• If there are few coffee beans left in the bean box, press and hold the bean emptying
button for at least one second to keep the appliance running until the ground coffee
blocked in the power supply channel is emptied, and then the appliance returns to nor-
mal operating status.
NOTE: If the ground coffee becomes obviously finer during use, or the coffee disc becomes
smaller after finishing brewing, please check the powder dispensing channel for any pow-
der blockage. Remember to clean the milling dispenser once a week.
Decalcify
When to clean:
• The appliance should be descaled when the Americano and Double Espresso indicators
flash at the same time.
• This notice appears when the machine has completed 500 coffee cycles.
How to clean:
1. Fill the water tank with water and softener to the maximum level indicated on the water
tank (the scale of water and softener is 4:1, details refer to the instructions for the sof-
tener. Please use "household descaler"), you can also use citric acid instead of descaler
(one hundred parts water and three parts citric acid).
2. Place a container on the drip plate.
3. Press and hold the Americano and Double Espresso buttons for one second at the same
time, and the appliance will enter the descaling procedure.
4. The descaling process takes about 10 minutes. The six indicator lights will flash slowly
from left to right.
5. Once descaling is completed, the hot water and manual cleaning indicators will stop
flashing.
6. The number of coffee brewing cycles will be reset to zero and counted again after desca-
ling is complete. The descaling warning will occur again when the appliance has brewed
500 accumulated coffee cycles.
16 E NGL I SH