Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical connection
Driving lamps
see illustration on page 4:
Fog lamps
9
see illustration on page 5:
Adjusting the lamps,
see illustration on page 6:
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps
provide optimum illumination.
Install relay with connection
terminals pointing downwards so
that they are protected against
splashing water.
Lay and connect wires according to
circuit diagram.
According to circuit diagram
auxiliary lamps are switched on
together with the existing main
beams.
Lay and connect wires according to
circuit diagram.
The correct visual aim is with the
top of the beam 4" below the lamp
center at 25 ft. The lamp shall be
centered laterally about a vertical
line directly ahead of the lamp.
A higher visual aim may be desired,
but the top of the beam should not
be higher than the lamp center level
at 25 ft.
If required, install switch in
dashboard.
Disconnect earth lead (-) from
battery for safety.
According to circuit diagram
auxiliary lamps can be switched on
in addition to the main beams with a
separate switch.
I
the
1 Vertical centerline ahead of left
headlamp
2 25 ft.
3 Centre of vehicle
4 Headlamp adjusting screen
5 Height of lamp centers (distance
from ground to center of lamp)
6 Vertical centerline ahead of right
headlamp
7 Distance between headlamps
II
the
Publicidad
