Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING YOUR APPLIANCE
• Steps To Replace Water Bottles
• Use a dean cloth to wipe off neck of bottle.
• Remove cap.
• Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands in
opening of bottle while placing in reservoir.
•
Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
• Wipe off any water which may have splashed on dispenser top.
Refrigerator Control
Turn the refrigerator switch on rear. The green indicator .vlll be lit on and the process begins. When
the refrigerator compartment reaches the right temperature in approximately 90 minutes the green
light will go off and you can proceed to load the compartment area.
>• Cold Water Control
Turn the cooling switch on. The green indicator will be lit on and the process begins. The first cyde
takes approximately 90 minutes for both the cold water and the fridge.
Hot Water Control
Turn heating switch on, the red indicator will be lit on and the unit will begin to heat the water. When
the water reaches the right temperature the red light goes off automatically. When the temperature
goes down to approx. 80° C {176 0 F), the red indicator will glow again and another heating process
starts.
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.
To get hot water.
♦
Squeeze safety valve on backside of handle and tilt faucet handle down.
♦
Continue holding safety valve while pushing down faucet handle as long as water is
dispensed.
♦
When faucet handle is released, make sure to return it to the original position until a
heard.
being
click is
^ Cup Dispenser (Optional)
A cup dispenser may be installed by using the mounting holes (covered with plastic caps) located
near the top of the side panel of the cooler. The cup dispenser comes equipped with a mounting
bracket and screws and may be ordered by completing the enclosed order form provided with your
instruction manual.
8
Publicidad
