GE 20 Manual Del Propietario E Instalación página 43

Performance Data Sheet
SmartWater Filtration System
MWF Cartridge
This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration
less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/5&*
200% safety factors built in for unmetered usage)
Standard No. 42: Aesthetic Effects
Parameter USEPA Influent
HCL Challenge Concentration
Chlorine - 2.0mg/L+ 10%
T&O - -
Particulate** - _> 10,000particles/mL
Influent
Average
1.96 mg/L
6,400,000 #/mL
Effluent
Average Maximum
0.06 mg/L 0.tl mg/L
58,833#/mL 150,000 #/mL
% Reduction
Average Minimum
9677% 9474%
99.t4% 9797%
Parameter
Turbiditg
Cgsts
Asbestos
Leadat pH6.5
Leadat pH8.5
Mercurgat pH6.5
Mercurgat pH8.5
Alachlor
Lindane
2,4-D
Toxaphene
Benzene
Carbduran
1,4 d icNorobenzene
Atrazine
USEPA
MCL
0.5 NTU
_> 99.95% Reduction
_> 99%Reduction
0.015 m g/L
0.015mg/L
0.002mg/L
0.002mg/L
0.002mg/L
0.0002mg/L
0.070mg/L
Standard No. 53: Health Effects
Influent
Challenge Concentration
11 + 1 NTU***
Minimum 50,000 L
107to 108fibers/L; > 10pm
0,15 mg/L+ 10%
0,15 mg/L+ 10%
0.006 mg/L + 10%
0.006 mg/L + 10%
0.04 mg!L+ 10%
0.002 mg/L + 10%
0.210 mg/L + 10%
Influent
Average
10,5 NTU
118,750 #/L
57 MF/L
0.1567 mg/L
0.1433 mg/L
0.0059 mg/L
0.0057 mg/L
0.0367 mg/L
0.0020 mg/L
0.2033 mg/L
Effluent
Average
0,t4 NTU
< I#/L
0,996MF/L
< 0,001mg/L
< 0,001mg/L
0.000350 mg/L
0,000325 mg/L
0,00023 mg/L
<0.00002 mg/L
0,00337 mg/L
Maximum
0.28NTU
4 #/L
< i MF/L
< 0.001 m g/L
< 0.001 m g/L
0.0007 mg/L
0.0006 mg!L
0.0004 mg/L
<0.00002 mg/L
0.011000 mg/L
% Reduction
Average Minimum
98.54% 97.20%
> 99.99% > 99.99%
99.60% 99.39%
99.36% 99.29%
99.30% 99.29%
94.70% 87.50%
93.20% 89.29%
99.34% 98.67%
99.00% 98.95%
98.32% 94.50%
0.003mg/L
0.005mg/L
0.040mg/L
0.075mg/L
0.003mg/L
0.015 mg/L + 10%
0.015 mg/L + 10%
0.080 mg/L + 10%
0.225 mg/L + 10%
0.009 mg/L + 10%
0.0160mg/L
0.0145mg/L
0.0830mg/L
0.2283mg/L
0.0087mg/L
0.00t00 mg/L
0.000500 mg/L
0.001000 mg/L
0.000500 mg/L
< 0.0005 mg/L
0.00t000mg/L
0.000500 mg/L
0.00t000mg/L
0.000500 mg/L
< 0.0005mg/L
93,44%
96,51%
9878%
9978%
9422%
91.67%
95.83%
98.65%
99.77%
93.33%
Tested using a flow rote of 0.50 gpm; pressure of 60 psig; pH of 7.5 +_0.5; temp. of 68° +_ 5°F (20°+_3°C)
** Measurement in Porticles/mL Particles used were 0.5-1 microns
*** NTU=Nephelometric Turbiditg units
Min.Required
Reduction
>50%
_>85%
Min. Required
Reduction
0.5 NTU
_> 99.95%
_> 99%
0.010mg/L
0.010mg/L
0.002mg/L
0.002mg/L
0.002mg/L
0.0002mg/L
0.070mg/L
0.003mg/L
0.005mg/L
0.04mg/L
0.075mg/L
0.003mg/L
Operating Specifications
[] Capacity: certified for up to 300 gallons (!!35 I);up to six months for models without a replacement filter indicator light;
up to one year for models with a replacement filter indicator light
[] Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock
[] Temperature: 55-100°F (0.6-58°C)
[] Flow rate: 0.5 gpm (1.9 Ipm)
General Installation/Operation/Maintenance
Requirements
[] Flush new cartridge atfull flow for 5 minutes to purge out trapped air.
[] Replace cartridge when the indicator light flashes or water flow rate is reduced on non-indicator units.
Special
Notices
[] Installation instructions, parts and service availabilitg, and standard warrantg are included with the product when shipped.
[] This drinking water sgstem must be maintained according to manufacturer's instructions, including replacement of filter cartridges.
[] Do not use with water that is microbiologicall9 unsafe or of unknown quality without adequate disinfection before or
after the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.
[] The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
[] Check for compliance with the state and local laws and regulations.
[] Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Systems must be
installed and operated in accordance with manufacturer's recommended procedures and guidelines.
Standard No. 42: Aesthetic Effects
Chemical Unit
Chlorine Taste and Odor
Mechanical Filtration Unit
Particulate Reduction, Class I
System Tested and Certified by NSF International against ANSI/NSF Standard 42 & 53 for the reduction of:
Standard No. 53: Health Effects
Chemical Reduction Unit
Alachlor and Atrazine Reduction
Benzene and Carbofuran Reduction
1,4 dichJorobenzene and 2,4-D Reduction
Lead and Lindane Reduction
Mercury and Toxaphene Reduction
Mechanical Filtration Unit
Turbidity Reduction
Cyst and Asbestos Reduction
Manufactured for: General Electric Company, Louisville, KY40225
EPA EST.No. 070595-MN-001
43