Fan Operation; Care And Maintenance - Lorell LLR33557 Manual Del Propietário

RESET INSTRUCTIONS
IF THE UNIT SHUTS DOWN PLEASE OPERATE AS FOLLOWS.
1) TURN THE UNIT OFF
2) UNPLUG UNIT WAIT 10 MINUTES
3) PLUG IN AND TURN ON

FAN OPERATION

To use the unit as a cooling air circulator without heat, turn the power and
setting control to .
IF YOUR HEATER FAILS TO OPERATE
• Be sure it is plugged in and that the electrical outlet is working.
• Check for any obstruction. If you find an obstruction turn the heater OFF.
Unplug the heater and wait at least ten minutes for it to cool. Carefully
remove the obstruction. Plug the heater back in and restart it as described
under OPERATION.
• If you still notice the same defect above mentioned, remove the plug from
the socket and have the appliance serviced by authorized service personnel
only.

CARE AND MAINTENANCE

We recommend that the heater be cleaned at least once a month and before
off-season storage.
• Turn the heater OFF and unplug it. Allow it to cool.
• Use a dry cloth to clean the external surfaces of the heater.
• DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION.
• Clean your heater using the above-mentioned steps, then pack the heater
in its original container and store it in a cool dry place.
• This heater does not disassemble.
• The motor is factory lubricated for life, and will require no further lubrication.
SPECIFICATIONS
Model No.: HF-0020T (LLR33557)
Voltage: 120V, 60Hz
Current: Maximum continuous draw: 12.5 Amps.
Power: I = 600 Watts, II = 900 Watts, III = 1500 Watts
Tolerances on all specifications: Approximately +5%, -10%.
4