Hotpoint Ariston TD 640 S GH/HA Manual De Instrucciones página 25

There is an adjustable L-shaped pipe itting on the appliance
supply ramp and this is itted with a seal in order to prevent
leaks. The seal must always be replaced after rotating the
pipe itting (seal provided with appliance). The gas supply
pipe itting is a threaded 1/2 gas cylindrical male attachment.
Connecting a lexible jointless stainless steel pipe to
a threaded attachment
The gas supply pipe itting is a threaded 1/2 gas cylindrical
male attachment.
These pipes must be installed so that they are never longer
than 2000 mm when fully extended. Once connection has
been carried out, make sure that the lexible metal pipe
does not touch any moving parts and is not compressed.
! Only use pipes and seals that comply with current national
regulations.
Checking the tightness of the connection
! When the installation process is complete, check the pipe
ittings for leaks using a soapy solution. Never use a lame.
Adapting to different types of gas
To adapt the hob to a different type of gas other than default
type (indicated on the rating plate at the base of the hob or
on the packaging), the burner nozzles should be replaced
as follows:
1. Remove the hob grids and slide the burners off their
seats.
2. Unscrew the nozzles using a 7 mm socket spanner, and
replace them with nozzles for the new type of gas (see
table 1 "Burner and nozzle characteristics").
In the case of the Mini WOK burner,
use a spanner with a 7 mm opening
to unscrew the nozzle (see igure).
3. Reassemble the parts following
the above procedure in the reverse order.
4. Once this procedure is inished, replace the old rating
sticker with one indicating the new type of gas used.
Sticker are available from any of our Service Centres.
• Adjusting the burners' primary air
Does not require adjusting.
• Setting the burners to minimum
1. Turn the tap to the low lame position;
2. Remove the knob and adjust the adjustment screw, which
is positioned in or next to the tap pin, until the lame is
small but steady.
3. Having adjusted the lame to the required low setting,
while the burner is alight, quickly change the position
of the knob from minimum to maximum and vice versa
several times, checking that the lame does not go out.
4. Some appliances have a safety device (thermocouple)
itted. If the device fails to work when the burners are set
to the low lame setting, increase this low lame setting
using the adjusting screw.
5. Once the adjustment has been made, replace the seals on
the by-passes using sealing wax or a similar substance.
! If the appliance is connected to liquid gas, the regulation
screw must be fastened as tightly as possible.
! Once this procedure is inished, replace the old rating
sticker with one indicating the new type of gas used. Stickers
are available from any of our Service Centres.
! Should the gas pressure used be different (or vary slightly)
from the recommended pressure, a suitable pressure
regulator must be itted to the inlet pipe (in order to comply
with current national regulations).
DATA PLATE
Electrical
see data plate
connections
This appliance conforms to the following
European Economic Community directives:
- 2006/95/EEC dated 12/12/06 (Low
Voltage) and subsequent amendments
- 2004/108/EEC dated 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 2009/142/EEC dated 30/11/09 (Gas) and
subsequent amendments.
- 2002/96/EC and subsequent
amendments.
GB
25