Sunny Health & Fitness PERFORMANCE INTERACTIVE Serie Manual Del Usuario página 8

We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY
(877-907-8669).
NOTE: If the bike is making unusual noises
when in use, inspect the bike carefully and
tighten any loose bolts and nuts especially the
2 Nylon Nuts (No. 28).
STEP 4:
Attach Left and Right Swing Bars (No. 49L
& No. 49R) to Left and Right Pedal Support
Tubes (No. 2L & No. 2R) with 2 Spacers (No.
19), 2 Flat Washers (No. 124) and 2 Nylon
Nuts (No. 28) and pre-secure with the Open
End Wrench (No. 123).
NOTE: Please do not fully tighten at this time.
Attach the Left Pedal Support Tube (No. 2L)
to the left side of the Crank (No. 41) with 1
Left Hinge Bolt (No. 44L) and 1 Wave
Washer (No. 32). Turn the Left Hinge Bolt
(No. 44L) counter-clockwise with your hand.
Then attach 1 Spring Washer (No. 45) and 1
Left Nylon Nut (No. 46L) to the end of Left
Hinge Bolt (No. 44L) and turn the Left Nylon
Nut (No. 46L) clockwise.
Attach the Right Pedal Support Tube (No.
2R) to the right side of the Crank (No. 41) with
1 Right Hinge Bolt (No. 44R) and 1 Wave
Washer (No. 32). Turn the Right Hinge Bolt
(No. 44R) clockwise with your hand. Then
attach 1 Spring Washer (No. 45) and 1 Right
Nylon Nut (No. 46R) to the end of Right
Hinge Bolt (No. 44R) and turn the Right
Nylon Nut (No. 46R) counter-clockwise.
The Left Hinge Bolt (No. 44L) is labeled L,
while the Right Hinge Bolt (No. 44R) is
labeled R. The Left Nylon Nut (No. 46L) is
BLACK and Right Nylon Nut (No. 46R) is
WHITE.
First, fasten Left and Right Nylon Nuts (No.
46L & No. 46R) and Left and Right Hinge
Bolts (No. 44L & No. 44R) using Allen
Wrench (No. 126) and Open End Wrench
(No. 123).
Second, fasten 2 Nylon Nuts (No. 28) using
Open End Wrench (No. 123).
Then fasten 2 Hex Screws (No. 26) for STEP
3 using 2 Spanners (No. 122).
Finally, cover 2 Nut Caps (No. 50) and 2 Nut
Caps (No. 48).
NOTE: Ensure that all bolts and washers are
in place and partially threaded in before
completely tightening any of them.
7