Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
INDOOR UNIT INSTALLATION
Installation Instructions - Indoor unit
Step 1: Select installation location
Before installing the indoor unit, you must
choose an appropriate location. The following
are standards that will help you choose an
appropriate location for the unit.
Proper installation locations meet the
following standards:
Good air circulation
Convenient drainage
Noise from the unit will not disturb other
people
Firm and solid-the location will not vibrate
Strong enough to support the weight of the
unit
A location at least one meter from all other
electrical devices (e.g. TV, radio, computer)
DO NOT install unit in the following locations:
Near any source of heat, steam, or
combustible gas
Near flammable items such as curtains or
clothing
Near any obstacle that might block air
circulation
Near the doorway
In a location subject to direct sunlight
NOTE ABOUT WALL HOLE:
If there is no existing refrigerant piping:
While choosing a location, be aware that you
should leave ample room for a wall hole (see
Drill wall hole for connective piping step)
for the signal cable and refrigerant piping
that connect the indoor and outdoor units.
The default position for all piping is the right
side of the indoor unit (while facing the unit).
However, the unit can accommodate piping
to both the left and right.
Refer to the following diagram to ensure
proper distance from walls and ceiling:
Minimum Space to the ceiling 5.9
inches (15 cm)
Minimum Space to
Adjacent Wall 4.75
inches (12 cm)
Minimum Space to the floor
78.7 inches
Step 2: Attach mounting plate to wall
• Remove the screw that attaches the
mounting plate to the back of the indoor
unit.
Minimum Space
to Adjacent Wall
4.75 inches
(12 cm)
Page 15
Publicidad
