Publicidad
The open channel at the rear is clearly shown. For the correct
operation of the appliance it is important that the top of the housing
unit is not blocked off. A channel depth of 40-50mm is normal with
most units.
A ventilation hole is required in the plinth of the unit; this allows air to
be drawn over the compressor & heat exchange. A decorative grille
is supplied with the appliance to finish this vent neatly. Alternatively
the required air flow can be achieved by removal of a thin section of
plinth (600mm x 10mm minimum).
As a rule, the more air that can get in and out, the better and more
efficient the operation of the product.
Installation into the cabinet
To ensure the appliance is level, you should use the height adjustable
feet at the front of the appliance. The ventilation system at the bottom
of the appliance must not be blocked
Push the appliance carefully into the cavity, make sure the appliance
is in the central position of the cavity. Following the steps on the next
page to fit the decor door, ensuring the door can be opened and
closed properly then tighten the screws on the top, hinge side and the
bottom.
18
Publicidad
