HSM MyBinding Securio C18 Instrucciones De Servicio página 15

5 Operation
WARNING
Before switching the machine on,
make sure that you observe all
safety instructions.
Switching on the shredder
• Connect the power plug of the machine
into a properly installed socket.
• Set mains switch at rear of paper shredder
to "I".
• Press the operation button.
The "Ready for operation" indicator
lights up.
Shredding paper
• When you feed paper, the light barrier
automatically starts the cutting unit.
Two seconds after the light barrier in the
paper feed opening is free again, the
cutting unit is switched off automatically
and the shredder switches to standby.
Shredding CDs and credit cards
(see "Proper Use")
WARNING
Depending on the type of material,
splinters could be produced when
shredding CDs. For this reason,
wear protective goggles.
Insert CD/credit card in centre of the feed
opening.
Switching off the shredder
• Press the operation button.
The "Ready for operation" indicator
goes out.
• Set mains switch at rear of paper
shredder to "0".
14
Other function modes
• Permanent mode
Function: Cutting unit runs continuously.
If no material is fed in within a period of
2 minutes, the cutting unit shuts down
and the shredder switches to standby.
Start: Press the operation button for four
seconds.
Premature cancellation: Press the
operation button.
• Sleep mode
Function: Two minutes after the last
paper feed operation, all consumers
that are not required are switched off
automatically.
The "Ready for operation" indicator goes
out briefl y at regular intervals.
The shredder starts automatically when
paper is fed in.
• Automatic shutdown
Function: If the shredder is not used for
one hour, it shuts down completely and
therefore does not consume any more
electricity (at night, at the weekend).
Restart: Press the operation button.
SECURIO C 18
english
05/2012