Husqvarna DS150 Manual Del Usuario página 3

Product description
The product is a drill stand for Husqvarna drill motors.
• The model DS150 can be used with drill bits with a
maximum diameter of 150 mm.
• The product is made of aluminum which makes it
light in weight. It has a built-in vacuum plate for
stable operation.
• The DS250 models can be used with drill bits with a
maximum diameter of 250 mm.
• The drill column can be tilted 0–60°.
• The DS250 models have a quick mounting plate for
the drill motor. On model DS150 the drill motor is
installed on a collar.
• A vacuum pump is available as an accessory for all
models.
Intended use
This product is used together with a Husqvarna drill
motor to drill in ceilings, walls and floors. The product
is used on concrete, brick and different stone materials.
All other use is incorrect.
The product is used in industrial operations by operators
with experience.
Symbols on the product
WARNING: This product can be
dangerous and cause serious injury or
death to the operator or others. Be careful
and use the product correctly.
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
1341 - 005 - 28.09.2023
Used if there is a risk of
Used if there is a risk of
Read the operator's manual carefully
and make sure that you understand the
instructions before you use the product.
Use approved hearing protection.
Note:
Other symbols/decals on the product refer to
special certification requirements for some markets.
Product damage
We are not responsible for damages to our product if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
Safety
Always use common sense
WARNING:
should you modify the original design of
the machine without approval from the
manufacturer. Always use original spare
parts. Unauthorized modifications and/or
accessories may lead to serious injury or
death to the user or others.
It is not possible to cover every conceivable situation
you can face when using a drilling machine. Always
exercise care and use your common sense. Avoid
all situations which you consider to be beyond your
capability. If you still feel uncertain about operating
procedures after reading these instructions, you should
consult an expert before continuing.
Do not hesitate to contact your dealer if you have any
more questions about the use of the machine. We will
willingly be of service and provide you with advice as
well as help you to use your machine both efficiently and
safely.
Under no circumstances
3