Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Stop spraying clean water and vacuum the waste water (Fig. 12). After using the device,
dry the surface with a dryer or let it air dry.
Switch off the device by pressing the power button. Fig. 13
6.
7.
Disconnect the device from the power supply.
Empty the clean and waste water from the tanks and clean the waste-water tank.
8.
Warning
-
Do not spray water continuously over the same spot.
-
Take special care when using the device to clean stairs.
-
After using the device, hang and wind the power cord in the power cord holder.
Cleaning embedded dirt
Warning:
-
You can add low-foam detergent in the clean-water tank or apply it directly on the stain.
-
Make sure the detergent will not damage the soiled surface before using it.
-
Do not use thinners, aniline, chloroform or flammable detergents.
Recommended liquids
-
Alkaline ionised water.
-
Low-foam detergent to the clean water tank combined with water in a 5:10 proportion.
-
Citric acid
-
Water with hydrochloric acid.
Non-recommended liquids
-
Neutral kitchen detergent.
-
Alkaline detergent.
-
Acid detergent.
1.
Apply detergent over the soiled surface, spray clean water and scrub the dirt with a brush
(19) to bring it to the surface.
Vacuum the dirt and do not let any detergent remain. Fig. 14
2.
Warning:
-
To know the detergent quantity and use, carefully read the manufacturer instructions.
-
Stop using the device when the water or foam in the waste-water tank (12) reaches the
maximum water level and clean the waste-water tank (12); otherwise, water may enter
the machine.
Using the right-angle suction nozzle
Press the suction nozzle against the soiled surface and move it from top to bottom. Fig. 15
ENGLISH
CONGA 3000 CARPETCLEAN
49
Publicidad
