Publicidad
Idiomas disponibles
Idiomas disponibles
5.3 Cleaning the clean-water tank
1.
Remove the clean-water tank (3) in the arrow direction, as shown in the assembly section.
Fig. 4
2.
Loosen the cap and empty the remaining water. Fig. 23
Tighten the cap of the clean water tank again (3) and install the empty tank.
3.
Press the power button (1) to turn on the device. Fig. 24
4.
5.
Press the water release button (7) to empty the remaining water in the device. Fig. 25
When it stops releasing water, turn off the device and unplug it from the mains.
6.
Tilt the machine and empty the remaining water at the bottom of the device. Fig. 26
7.
5.4 Cleaning the suction nozzle
Press the suction nozzle release button (32) and separate it from the hose bracket (8).
1.
Fig. 27
Remove the front cover (33) by lifting it with your finger. Fig. 28
2.
Rinse the suction nozzle.
3.
4.
Install the suction nozzle cover again. Make sure the pins are correctly placed in the holes
and press these parts until they click. Fig. 29-30
Figure 28-29:
23. Suction nozzle release button
24. Suction nozzle front cover
25. Holes
26. Pins
-
When cleaning the suction nozzle, empty the water outlet (20) if clogged. Fig. 31
-
Check the hose (5) is not damaged and has no leaks. Fig. 32
5.3 Cleaning the air inlet sponge and the filter sponge
Rinse the air inlet sponge (36) and the filter sponge (37) after every use and replace them if
worn.
Figure 33
27. Air inlet sponge (located on the bottom of the waste-water tank)
28. Filter sponge (located on the bottom of the clean-water tank)
-
We recommend removing them with tweezers.
-
Let them air dry after cleaning.
-
Install the parts again in the machine after cleaning.
-
After cleaning it, store the machine in a dry place at room temperature and avoid direct
sunlight.
ENGLISH
CONGA 3000 CARPETCLEAN
51
Publicidad
