Kohler K-14533 Guia De Instalacion página 3

Lift Rod
Washer
Escutcheon
Supply
Hoses
1. Faucet Body Installation
NOTE: For single-hole bidets, the escutcheon, spacer and gasket are
not required. Use the rubber washer only.
Apply a bead of plumbers putty to the underside of the faucet
body according to the putty manufacturer's instructions.
Set the spacer and gasket, with the gasket down, under the center
hole of the escutcheon.
Align the center hole of the escutcheon with the center hole of the
bidet.
Slide the washer over the supply hoses and into the groove on
the faucet body.
Insert the faucet supply tubing into the hole in the bidet.
Insert the lift rod into the hole at the rear of the faucet body.
From the underside of the bidet, place the bracket and nut onto
the mounting stud. Position the faucet with the lift rod toward
the back.
Tighten the nut securing the faucet to the bidet.
Remove excess putty from the escutcheon if it is installed.
Kohler Co.
Bracket
Faucet
Body
Mounting
Stud
Spacer
3
Hoses
Nut
Lift
Rod
1015486-2-B