Franke SLIM45 Manual De Instalación Y Servicio página 12

EN
5. Is the disposer earthed?
Warning: this appliance must be earthed!
In the event of a malfunction of breakdown,
earthing reduces the risk of shock. This
disposer must be connected to an earthed,
metal, permanent wiring conductor and
connected to the equipment earthing terminal
or lead on the disposer.
Electrical connection for
disposer provided with
prewired molded plug and
lead.
For continuous feed only
- not batch feed
3A
Fixed wire electrical
connection
3B
Replacing the fuse in moulded plugs
The correct fuse cover must be refitted when
changing the fuse.
1. Remove the fuse cover and slide the fuse out.
2. Replace it with a 13 Amp ASTA fuse
(approved to BS 1363). Should the fuse cover
be lost or damaged, an exact replacement
should be used. These are available from an
approved service agent, listed below. Never
use the plug without the fuse cover fitted.
SLIM45 / SLIM50 / SLIM75 / SLIM75BF / SLIM100 / SLIM125
13 Amp fused
double pole
switched spur
wall mounted
Plug socket
13 Amp fused
double pole
switched spur
wall mounted
13 Amp fused
Spur mounted
Under sink
Attaching discharge elbow
1. Connect the waste elbow to the disposer
by sliding the flange against the rubber
gasket on the elbow and tightening the
screws into the disposer (fig. 4A).
2. Connect bottom of the elbow by tightening
the slip nut (fig. 4B). If using a straight pipe,
it must have a lip similar to the one on the
elbow.
3. Remove the gasket from the elbow and
install it on the straight pipe with the flat end
of the gasket facing toward the disposer
discharge opening.
Rubber
gasket
4A
4. If you are connecting to a dishwasher, return
to Plumbing connection section (fig. 2A-B).
If not, make sure all plumbing connections
are tight and in accordance with all
plumbing codes and ordinances.
5. Run water and check for leaks.
12
4B
P-trap